Oil impregnated bronze bearing block Can Be Stored for Periods without considerable deterioration or loss of oil if Kept in metal gold --other non-absorbing containers. Paper, cloth, and cardboard are not Appropriate for Storing bearings As They will wick oil out of the bushings. Plastic resealable bags are preferred. Store oil impregnated bronze bearings at room temperature. Proximity to heat Could causes oil loss by sweating, in case qui re-oiling is Necessary before installation. Wash oil in storage if the conditions are in doubt. After machining of the bearings or loss of oil Following During storage, immerse in high quality mineral oil (SAE 30) at 140 degrees F to 160 degrees F for 10 to 15 minutes and cool in cold Then oil.
Fitting and pillow bearing block Installation
Before Installing sour Make That all sharp edges are removed from the housing and mating shaft. The bearing must be free from grit and dust. Oil impregnated bronze bearings are usually installed by a moyen de shouldered arbor plug inserted into an arbor press. A chamfer in the housing bore is Necessary to serve as a lead for the bearing. A year-chamfered edge might shear metal from the bearing OD, gravement Reducing the press fit. The OD chamfer on the lead edge of the bearing acts as the pilot, and the ID in the chamfer bearing reserves as the lead When the shaft is inserted. Any out of roundness is provided corrected When the bearing is pressed into the housing.
more in www.bearingseat.com