I was installing this by myself

It doesn’t look pretty right now, but it’ll look greater when it’s finished. The great thing about this system is that all of the moving/rolling parts are actually included in the square rail. That shows that this hardware can often be painted any color you want, and there will be no deterioration that will rub the paint off with time. I’ll be painting the actual door brackets black making sure that they’ll blend in together with my doors, and the rest will be covered absolutely when everything is complete.So here are the details of the barn door hardware, and how I installed it…1st, I installed very easy door casing around our door. Then above the very best casing, I attached a 10-foot 1″ x 6″ piece of lumber using 3-inch framing nails. (Lots of them! ) I thought this was originally an exterior wall membrane, so this wall is actually load-bearing, and this doorway features a solid wood header earlier mentioned it. My walls are lined with shiplap beneath the drywall. So I shot the nails within at random, knowing of which wherever I placed these individuals, I’d be hitting solid wood. So if your situation takes a different approach (which is very likely), you definitely should screw or nail the following into studs.how to setup square rail door track - cheap barn door hardware - 1And then because my doors tend to be thicker than standard panels, and I needed to make certain there was plenty regarding clearance for my gates to slide past the actual door casings, I added another 1″ times 6″ x 10′ piece of lumber in addition to the first one, again attaching it with 3-inch framing nails. Before I attached the following second board, I marked and measured the location where the bottom of the metal rail were required to be, and I stalled the board to ensure that the bottom of the board is perfectly lined up while using bottom of the rail.And then I attached the rail into the 1″ x 6″ table. Because I was the installation of a 10-foot track on the wall that’s only three inches wider approach rail, I had to pre-assemble the wheel/door bracket assembly and place them into your track before installing this track.how to install square rail door course - cheap barn doorway hardware - 2This specific definitely made things far more challenging. I was installing this by myself, as well as the whole thing was very heavy. Those wheels move back and forth very easily, and so they kept sliding between the two, throwing me off sense of balance. Holding that rail up with one hand and trying to screw in the 1st screw was almost an excess of for me to do on by myself, but I finally became it. In order to undertake it by myself, I had to mark and measure the location where the first lag screw were required to go (I started with all the middle one), and then pre-drill the hole beforehand. That way when I climbed through to the ladder and held the metal track in a hand, while holding the drill while in the other, I knew where that lag bolt had to go. It was extremely tough, and I definitely suggest having someone help you install this hardware.The following is what the track seems as if. You can see here the location where the wheel assembly slides to the rail, and then with the bottom of the rail.https://www.dndhardware.com/Door-Handle-pl0667.html door handle