Common Plumbing Problems and How to Prevent Them

Plumbing problems can be inconvenient and costly if not addressed promptly. At SJS Plumbing, we provide expert advice on common plumbing issues and tips on how to prevent them. Blocked drains are a common plumbing issue caused by the buildup of hair, grease, soap, and other debris. To prevent blocked drains: Use drain guards: Install drain guards in sinks and showers to catch hair and debris. Avoid pouring grease down the drain: Dispose of grease in the trash instead of pouring it down the drain. Flush drains regularly: Use hot water and baking soda to flush drains and prevent buildup. Leaking Faucets Leaking faucets can waste a significant amount of water and increase your utility bills. To prevent leaking faucets: Replace washers regularly: Worn washers are a common cause of leaks. Replace them as needed. Tighten fittings: Ensure that all fittings are tight and secure to prevent leaks. Check for corrosion: Inspect faucets for signs of corrosion and replace any damaged parts. Running Toilets A running toilet can waste a large amount of water and lead to higher bills. To prevent running toilets: Check the flapper valve: Ensure that the flapper valve is sealing properly and replace it if worn. Adjust the float: Adjust the float to ensure that the tank fills to the correct level. Inspect the fill valve: Ensure that the fill valve is working correctly and replace it if necessary. Low Water Pressure Low water pressure can be caused by various factors, including clogged pipes and faulty fixtures. To prevent low water pressure: Clean aerators: Remove and clean faucet aerators to prevent clogs. Check for leaks: Inspect your plumbing system for leaks and repair them promptly. Replace old pipes: Replace old, corroded pipes to improve water pressure. Water Heater Issues Water heater problems can disrupt your hot water supply and lead to costly repairs. To prevent water heater issues: Perform regular maintenance: Flush the tank annually to remove sediment buildup. Inspect the anode rod: Check the anode rod every 2-3 years and replace it if necessary. Monitor temperature settings: Keep the thermostat set at 120°F to prevent overheating. Conclusion Preventing common plumbing problems requires regular maintenance and proactive measures. By following these tips, you can keep your plumbing system in good condition and avoid costly repairs. Trust SJS Plumbing for expert plumbing services and advice. Need help maintaining your hot water system? Contact SJS Plumbing today! visit our website https://sjsplumbing.com.au/ to schedule a maintenance service.