Separate the cooling water

JUST ONE. Cooling water system with EPS moulding machine the labels factorySeparate the cooling water for mould with all the water for vacuum. Using a high efficient vacuum procedure, the machine should mainly make use of vacuum cooling while contemplating water cooling as subsidiary, which could greatly increase the proficiency.Adopting high temperature chilling water (50-55 degrees) in order to cool the eps mould, yet cold cooling normal water (25-35 degrees) for vacuum cleaner spray and vacuum knock out. Different water temperatures won't increase the service lifetime of mould and vacuum pump, but also improve the cooling speed a bunch because vaporized high-temperature mineral water absorbs the heat in the process in vacuum environment.A COUPLE OF. High efficient vacuum programIt adopts the hypothesis of central vacuum program that vacuum kept inside the pipe constantly. When cooling is necessary, hot air inside the mould will be sucked out quickly, together the vaporization of the particular high-temperature water also takes a considerable amount of heat away, which enables the mould to be cooled down speedily. The heat taken with the vaporization of 1KG water is equal to the heat taken simply by 7KG cooling water of 25 degrees spraying upon the mould.3. Three separate water pools in combination with primary and secondary cooling towers to control three different water temps.Hot pool: 65-75 degree. Water used for the boiler can be taken from here by way of filter. It should be cooled with the primary cooling tower then transported towards mould cooling pool.Would mould cooling pool, temperature could be 45-55 degree, used with regard to mould cooling. It is suppose that they are delivered to vacuum customizable pool via secondary air conditioning water tower.Vacuum soothing pool: temperature is among 25-35 degree used regarding cooling vacuum tank apply and vacuum pump.SOME. You are recommended to use central vacuum system if you'll find more than 3 EPS moulding machine in the factory.Central vacuum system shows expression to high economical efficiency to get more detailed than 3 EPS moulding unit, power saving at lowest 40%, and greatly improvement of the production. We recommend one-bye-one network (modular type) but comparatively independent central vacuum technique, Every set of core vacuum system could assist utmost 15 EPS moulding equipment, and every single vacuum product is connected to main tube, which besides is segregated by manual butterfly valves. This means vacuum stays equally around every section, and the plant may not be interrupted as the matter of vacuum trouble.eps mould machine. JPG.https://www.fang-yuan.com/Pre-expander-Machine-pl523714.html

201911ld