How to Refill HP Cf226x Toner Cartridge With DIY?

Original hp toner cartridges cannot be filled directly. Many people run out of the original cartridge and discard it. In fact, you can DIY to fill the toner, so you can recycle 1-2 times. Below cf226x toner, for example, we teach you to achieve HP powder cartridges.
First of all, prepare the necessary tools and accessories. Each screwdriver has different specifications and each has its own purpose. The electric drill is used to open the powder tank.
Maintenance and powdering process is mainly a process of disassembly and installation. Maintenance is the replacement of accessories. The accessories of such drums are mainly scraper, magnetic roller and charging roller in the following figure.
Remove the two screws on the caliper baffle on the right side of the cartridge and remove the wick.
Remove the charging roller. Behind the drum core is a charging roller. Take out the pincers.
To remove the pin, this step is more critical. Using a screwdriver and pliers, pulling out the pin from the inside can separate the drum.
1, pay attention to the position of the screwdriver
2, with pliers
3, after the pin out of the pin out, out with pliers clip out
Drum separation and waste toner compartment after drum separation
Remove the scraper above the waste toner cabin
It is better to open the waste toner compartment and drill with a power drill than to use a hot iron.
First drill a small space from the inside with a small drill bit, pay attention to the position, and then drill a hole from the back with a big drill No. 7 bit. Drill the well's waste toner compartment, seal it with a transparent tape, and later pour waste powder from this place.
Handle the powder tank.
Remove the plastic plate on the left side of the powder compartment. Pay attention to the left hand to press the main magnetic roller, carefully remove, if not pay attention, it is easy to break the spring on the side of the magnetic roller.
After completion, according to the above steps, re-install the cf226x toner immediately. After that, add powder from the powder adding port and pour the waste powder from the waste powder port. Replace them according to the above steps when the drum core, magnetic roller, and charging roller need to be replaced.