You are here

Reset Guide of Brother TN450 Toner

Submitted by v4inktoner on Thu, 02/02/2017 - 23:51

First, we will introduce you to the ink cartridges basics.  Each series mentioned here includes a standard yield and high yield cartridge option (we list the standard yield cartridge number first, followed by their high yield counterpart). The term high yield is used to describe printer ink cartridges that contain more ink.  If you are using a high yield printer cartridge you will get more prints due to the higher ink capacity.  The moderately filled standard print cartridge is the most common option however, producing a smaller number of prints than the high yield.  Consumers that only print on occasion will be happy investing in these less expensive cartridges, but if you print frequently, it’s probably better to go for the high yield.  For example, the standard yield TN420 offers a yield of 1,200 pages, while the high yield TN450 offers 2,600 pages. Compatible versions of the Brother brand are worth considering if you are looking to save some cash.   
How To Reset Brother TN450 Toner:
The following is a step by step instruction on how to reset and install a new Brother TN450 Toner Cartridges:
To replace new toner cartridge, please remove old cartridge from the drum unit before installing new toner cartridge.
1. Toner sensor needs to be reset. Please do the following steps to reset the toner sensor.
2. Open the front cover and leave open while completing the following steps.
Turn the printer off.
Hold the ‘go’ button (or “start’ button) while turning the printer on. All panel lights should be on.
Release the ‘go’ button (or “start’ button).
Press the ‘go’ button (or “start’ button) 2 times.
Press the ‘go’ button (or “start’ button) 5 times.
The toner light should be off.
The paper light should be on or flashing.
Close cover. The ready light should be the only light on.
3. If printer pops up errors, please check the gear of cartridge to see if it’s in the right place.
If it’s in wrong position, please use fingers to turn the gear anti-clockwise with 45 angles and this will be able to reset and put back to the printer for use..